Configuring the system settings (ADVANCED SETUP menu)
34
En
Configure the system settings of the unit while viewing the front display.
1
Turn off the unit.
2
While holding down RETURN on the front
panel, press
A
(power).
3
Rotate SELECT/ENTER to select an item.
4
Press SELECT/ENTER to select a setting.
5
Press
A
(power) to set the unit to turn off and
turn it on again.
The new settings take effect.
Change the unit’s speaker impedance settings depending
on the impedance of the speakers connected.
Settings
Change the unit’s remote control ID so that it matches the
remote control’s ID (default: ID2). When using multiple
Yamaha AV receivers, you can set each remote control
with a unique remote control ID for its corresponding
receiver.
Settings
ID1, ID2 (default)
■
Changing the remote control ID of the
remote control
1
To select ID1, while holding down the ID, hold
down numeric key “1” for more than 3
seconds.
To select ID2, while holding down the ID, hold
down numeric key “2” for more than 3
seconds.
Once the remote control code is successfully
registered, “Rem: Success” appears on the front
display.
If “Rem: Fail” appears on the front display,
registration has failed. Repeat from Step 1.
y
The registered remote control codes (p.36) are not cleared even if
you change the remote control ID.
Configuring the system settings (ADVANCED SETUP menu)
ADVANCED SETUP menu items
Item
Function
Page
SP IMP.
Changes the speaker impedance
setting.
REMOTE ID
Selects the unit’s remote control ID.
INIT
Restores the default settings.
UPDATE
Updates the firmware.
VERSION
Checks the version of firmware
currently installed on the unit.
A
(power)
SELECT/ENTER
RETURN
Changing the speaker impedance
setting (SP IMP.)
4
MIN
Select this option when you connect 4-ohm
speakers to the unit.
8
MIN
(default)
Select this option when you connect 8-ohm or
higher speakers to the unit.
Selecting the remote control ID
(REMOTE ID)
SPIMP.8MIN
REMOTEIDID2