Yamaha QL5, Справочное руководство

Страница: 18 / 294

Input and output patching
Reference Manual
18
CH SELECT screen
1
Category select list
Select the category of the channel. The categories correspond to the following channels.
They vary depending on the output port type.
• MIX/MATRIX ................................ MIX1–MIX16, MATRIX1–MATRIX8
• ST/MONO/MONI/CUE ................. STEREO L, STEREO R, MONO(C), MONI L,
MONI R, MONI C, CUE L, CUE R, SMON L, SMON
R, SMON C, SMON LFE, SMON Ls, SMON Rs,
MMTX L, MMTX R, MMTX C, MMTX LFE, MMTX
Ls, MMTX Rs
• DIRECT OUT 1–32 ...................... CH1–CH32 Direct Outs
• DIRECT OUT 33–64 .................... CH33–CH64 Direct Outs
• INSERT 1 OUT 1–32 ................... CH1–CH32 Insert 1 Outs
• INSERT 1 OUT 33–64 ................. CH33–CH64 Insert 1 Outs
• INSERT 1 OUT MIX/MATRIX ....... MIX1–MIX16, MATRIX1–MATRIX8 Insert 1 Outs
• INSERT 1 OUT ST/MONO ........... STEREO L, STEREO R, MONO (C) Insert 1 Outs
• INSERT 2 OUT 1–32 ................... CH1–CH32 Insert 2 Outs
• INSERT 2 OUT 33–64 ................. CH33–CH64 Insert 2 Outs
• INSERT 2 OUT MIX/MATRIX ....... MIX1–MIX16, MATRIX1–MATRIX8 Insert 2 Outs
• INSERT 2 OUT ST/MONO ........... STEREO L, STEREO R, MONO (C) Insert 2 Outs
• CASCADE MIX/MATRIX .............. MIX1–MIX16, MATRIX1–MATRIX8
• CASCADE ST/MONO/CUE ......... STEREO L, STEREO R, MONO (C), CUE L,
CUE R
NOTE
In the case of QL1, channels that do not exist on the model will not be shown.
2
Channel select button
Select the channel to be assigned to the output port from the current category.
3
CLOSE button
Closes the screen.
Inserting an external device into a channel
You can insert an effect processor or other external device into the signal path of an INPUT,
MIX, MATRIX, STEREO, or MONO channel. When doing so, the type of input/output port
used for the insertion and the location of the insertion in/out can be specified individually for
each channel.
NOTE
If you install a digital I/O card in a slot and digitally connect an external device, you must
synchronize the word clock of the QL console and the external device (
page 211 ).
1
2
3
STEP
1.
Use the Bank Select keys in the Fader Bank section and the [SEL] keys on the top
panel to select the channel where you want to insert the external device.
2. Press the popup button in the INSERT field in the SELECTED CHANNEL VIEW screen.
3. Press the INSERT OUT or INSERT IN button.
4.
Select an output port or an input port.
5. Press the INSERT ON button.
SELECTED CHANNEL VIEW screen INSERT/DIRECT OUT window (1ch)