1
Video Unit
Thank you for purchasing the Video Unit.
To ensure correct usage, please read this instruction manual thoroughly.
This Video Unit is for use only with the following model:
PDM-4210E
chassis model
Preparations for Installation
* When installing the video unit, please be sure to turn off the power
switch and disconnect the power plug from the power outlet.
* Set a cushioning material (for example, the packing bag of the
plasma monitor) on a flat surface or table to prevent damage to the
plasma monitor, then gently place the plasma monitor face down on
the cushioning material. Ensure that there are no foreign objects on
the cushioning material before placing the plasma monitor on it.
* If you wish to use the pedestal, you can install the video unit after
mounting the plasma monitor on the pedestal.
* Please use a phillips screw driver for installation.
Cushioning Material
Pedestal
Installation Instructions
1. Blanking Plate Removal
Remove the two screws marked (a) in the diagram at right,
and remove the blanking plate.
2. Screws for Fixing Video Unit Removal
Remove the two screws marked (b) in the diagram at right.
These screws are used to fix the video unit in place.
3. Video Unit Installation
Set the video unit in the concave installation bay in the
plasma monitor.
Push the video unit toward the connector of the plasma
monitor until it is fully in position.
4. Fixing the video unit in place
To fix the video unit in place, replace the two screws marked
(b) you removed in step 2 back in their original screw holes
and tighten them.
Note -
The correct screw torque is 0.5 -0.8 N•m {5-8
kgf•cm}. Over torque could damage the screw
hole.
(a)
(a)
(b)
(b)
Plasma Monitor
Blanking Plate
screws (a)
screws (b)
Connector
Video Unit
(b)
(b)
screws (b)
Please read the user’s manual of the plasma monitor for an explanation of how to connect cables and operate.
ENGLISH
PTB-4210.qxd 2003.12.23 11:54 ページ 1 (ブラック 版)
