Yamaha P7000S - Amplifier, Руководство пользователя

Страница: 10 / 16

10
■
Wirin g
5-way bindin g post
(1) Turn off the POWER switch.
(2) Remove the cover attachment screws and remove the pro-
tective cover from the speaker terminals.
(3) Remove about 15 mm of insulation from the end of each
speaker cable, and pass the bare wire through the holes in
the appropriate speaker terminals. Tighten the terminals to
securely clamp the wires. Refer to page 9 for speaker
polarities.
Note to us er s in the U S A:
Ple as e us e Cl ass 3 wiring. (P7000 S , P5000 S )
Ple as e us e Cl ass 2 wiring. (P 3 500 S , P2500 S )
Be sure that the bare wire ends do not jut out from the ter-
minals and touch the chassis. The following shows how
the cable should look when correctly attached.
(4) Reattach the protective cover over the speaker terminals.
S peakon connector
(1) Turn off the POWER switch.
(2) Insert the Neutrik NL4FC plugs into the Speakon connec-
tor on the rear of the amplifier, and turn clockwise to lock.
Neutrik NL4FC plu g s
Phone jack
(1) Turn off the POWER switch.
(2) Insert the phone plug into the jack on the rear of the ampli-
fier.
S crew
15mm
* Act ua l s ize
*
S pe a ker c ab le
Ch ass i s
B a re wire
CHANNEL
S TEREO or PARALLEL BRIDGE
1+ A+ 1+ +
1– A– 1–
2+ B+ 2+ –
2– B– 2–
Ne u trik NL4FC pl u g s
CHANNEL
1+ B+
1– B–
A
B