3
RX-E400
Red (+)
Red line
Speaker (L)
Speaker (R)
Black line
Red line
How to connect:
1
Loosen the knob.
2
Remove the insulation coating at the extremity of each speaker
cable by twisting the coating off.
3
Insert the bare wire.
4
Tighten the knob and secure the cable.
Test the firmness of the connection by pulling lightly on the
cable at the terminal.
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or the receiver, or both of
them.
The front cover is fastened to the enclosure at four point and can be
removed if desired. To remove the cover, hold on to both sides and
slowly pull straight away from the speaker.
To reattach, line up the four pegs on the inner surface of the cover
with the four corresponding holes on the speaker and push gently.
REMOVING THE FRONT COVER
Note
When the cover is removed, be sure not to touch the
speaker units with your hands or to exert excessive force
with tools.
Type ............................................. 2-way bass-reflex speaker system
Magnetic shielding type
Driver .................................................... 13 cm (5-1/4") cone woofer
2.5 cm (1") dome tweeter
Impedance .................................................................................. 6
Ω
Frequency Response ............................................... 55 Hz to 28 kHz
Nominal Input Power ............................................................... 60 W
Maximum Input Power ........................................................... 110 W
Sensitivity ................................................................ 87 dB/2.83 V/m
Crossover Frequency ............................................................... 3 kHz
Dimensions (W x H x D) ................................. 186 x 300 x 223 mm
(7-5/16" x 11-13/16" x 8-13/16")
Weight ......................................................... 4.3 kg (9 lbs. 8 oz.) x 2
Accessories ................................................. Speaker cable (4 m) x 2
* Specifications are subject to change without notice due to
product improvements.
* Care should be taken not to exceed the input power values noted
above.
SPECIFICATIONS
Loosen
Tighten
Black (–)
Speaker output terminals of
the receiver
When using a banana plug
1
Remove the cover by pulling it toward you.
2
Tighten the terminal knob.
3
Simply insert the banana plug into the terminal.
3
1
2
Banana plug
