background image

3

• Place the speakers on a sturdy, vibration-free surface.

You may not be able to obtain good bass quality when
the speakers are placed directly on the floor. Put a
block, etc. under the speakers.

• Better stereo images will be obtained when the

speakers are slightly angled in towards the listening
position.

The front cover is fastened to the enclosure at four point
and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the
speaker.
To reattach, line up the four pegs on the inner surface of
the cover with the four corresponding holes on the
speaker and push gently.

REMOVING THE FRONT COVER

Type ............................. 2-way bass-reflex speaker system

(Magnetic shielding type)

Driver ........................................... 13 cm (5") cone woofer

2.5 cm (1") dome tweeter

Nominal Input Power ............................................... 60 W
Maximum Input Power ........................................... 110 W
Impedance .................................................................... 6 

Frequency Response ................................ 55 Hz – 28 kHz
Sensitivity ................................................ 87 dB/2.83 V/m
Crossover Frequency ............................................... 3 kHz
Dimensions (W x H x D) ................. 186 x 300 x 222 mm

(7-5/16" x 11-13/16" x 8-3/4")

Weight ........................................... 4 kg (8 lbs. 13 oz.) x 2
Accessories .................................. Speaker cable (4 m) x 2

* Please note that all specifications are subject to change

without notice.

* Care should be taken not to exceed the input power

values noted above.

SPECIFICATIONS

Note
When the cover is removed, be sure not to
touch the speaker units with your hands or to
exert excessive force with tools.

PLACING THE SPEAKERS

How to connect:

1

Loosen the knob.

2

Insert the bare wire. [Remove the insulation coating at
the extremity of each speaker cable by twisting the
coating off.]

3

Tighten the knob and secure the cable.
Test the firmness of the connection by pulling lightly
on the cable at the terminal.

Note
Do not let the bare speaker wires touch each
other as this could damage the speaker or the
amplifier, or both of them.

Good

No Good

Note
These speakers feature a magnetically shielded
design, but there is still a chance that placing
them too close to a TV set might impair picture
color. Should this happen, move the speakers
away from the TV set.

Отзывы: