E-
4
■
Placing the center speaker
NS-CLC5
Place the speaker on the TV or inside the TV rack
so that it is stabilized.
Attaching the stand
1.
Decide the location where you want to place
the speaker.
2.
Affix the double-sided adhesive tape on the
bottom of the speaker.
3.
Attach the supplied stands 8 mm from the
corner of the speaker bottom.
■
Placing the center speaker on top
of the TV
Affix the supplied fasteners to the bottom of the
stands. Peel off the seal and attach the center
speaker to the top of the TV.
Notes:
• Do not place the speaker on top of the TV whose
area is smaller than the bottom area of the speaker.
If placed, the speaker may drop out causing an
injury to you.
• Do not place the speaker on top of the TV with an
inclination.
• Do not touch the adhesive surface after peeling off
the seal as this will weaken its adhesive strength.
• Thoroughly wipe clean the surface where the
fastener is to be applied. Note that adhesive strength
is weakened if the surface is dirty, oily or wet and
that this may cause the center speaker to drop.
■
Placing the surround speaker
NS-ELC5
• Attach the non-skid pads to the bottom of the
speaker, and then place the speaker on a level
hard surface.
• Using non-skid pads prevents the speaker from
sliding when it vibrates, and ensures quality
sound production.
8 mm
NS-CLC5
Double-sided
adhesive tape
Stand
Fastener
TV or rack
side view
TV set
Stand
Fastener
Peel off
the seal
Double-sided
adhesive tape
40 - 50 mm
Note:
You can also use the screw holes on the bottom of the
surround speakers NS-ELC5 for installing the
speakers on commercially available speaker stands.
• Before installing, please refer to the instruction
manual of the speaker stand.
Non-skid pad
60
mm
A screw with a diameter
of 6 mm can be used
(Hole depth: 8 - 9 mm)
0523_NS-LC5_PC5_en.fm Page 4 Monday, May 23, 2005 6:54 PM