9
En
Before making connections, make sure that the amplifier/receiver is switched off.
• When connecting, also refer to the owner’s manual of the connected equipment.
• Connect the push input terminals at the rear of the speakers to the speaker output
terminals of the amplifier/receiver with the speaker cables (not included).
• Connect each speaker making sure not to reverse the polarity “+” (red), “–”
(black). If the speaker is connected with reversed polarity, the sound will be
unnatural and lack bass.
CONNECTING YOUR AMPLIFIER/RECEIVER
Connections
How to connect
1
Remove approximately 10 mm (3/
8”) of insulation from the end of
each speaker cable using wire
strippers, and then twist the
exposed wires of the cable
together to prevent short circuits.
2
Press and hold down the speaker
terminal.
3
Insert the bare wire into the hole in
the side of each terminal.
4
Release the terminal.
• Test the firmness of the connection by
pulling lightly on the cable at the
terminal.
CAUTION
• Do not let the bare speaker wires
touch each other as this could damage
the speaker or amplifier/receiver, or
both.
1
10mm
(3/8")
No Good
Good
2
3
+
-
+
-
-
+
A
L
R
B
+
-
+
-
+
-
N
S
-IC400 (R)
Receiver or
amplifier
S
peaker output
terminals
N
S
-IC400 (L)
NS-IC400.book 9 ページ ２０１０年１０月１９日 火曜日 午後２時５３分
