B
C
D
A
A
A
B
D
B
C
B
A
C
D
アウトドアスピーカー
A
B
C
D
To wall / ceiling mount the speakers, use the included bracket.
A
Using the bracket as a template mark the locations (four points) of the key hole
slots on the mounting area.
B
Using appropriate hardware (not included) securely fasten the bracket to the wall /
ceiling.
C
Position the speaker in the bracket and secure the speaker by using the two knobs
included.
D
Rotate the YAMAHA emblem according to the position of the speaker.
When using the brackets to mount the speakers on a wall / ceiling, please use safety
wire (not included) between the speaker and the bracket to prevent the speaker from
falling. Fix the safety wire with M5 screw (inch screw: No. 10-32) by using the screw
hole [diameter: 5 mm (1/4
″
), depth: 15 mm (5/8
″
)] at the rear of the speakers. For
security, please confirm that installed screw is in the screw hole more than 10 mm
(3/8
″
).
When placing the speakers on a flat surface, to enjoy the high sound quality, stabilize
the speakers using the included non-skid pads. Affix the non-skid pads to prevent the
speakers from moving as a result of vibration, etc.
A
When placing the speakers vertically, attach the bracket and the knobs to the
speakers, and affix the non-skid pads on the bracket. When placing the speakers
horizontally, attach the knobs to the speakers, and affix the non-skid pads on the
side of the speakers.
B
Rotate the YAMAHA emblem according to the position of the speaker.
Before making connections, make sure that the amplifier / receiver is switched off.
CONNECTIONS
• Connect the input terminals at the rear of the speakers to the speaker output
terminals of the amplifier / receiver with the speaker cables (not included).
• Connect each speaker making sure not to reverse the polarity “+” (red), “–” (black).
If the speaker is connected with reversed polarity, the sound will be unnatural and
lack bass.
HOW TO CONNECT
A
Remove approximately 10 mm (3/8
″
) of insulation from the end of each speaker
cable and twist the exposed wires of the cable together to prevent short circuits.
B
Unscrew the terminal knob.
C
Insert one bare wire into the hole in the side of each terminal.
D
Tighten the terminal knob to secure the wire.
2A
MOUNTING THE SPEAKERS
If speaker cable (not included) is being fed from a hole in the wall / ceiling behind the
bracket, pull this speaker cable through the hole in the bracket before mounting the
bracket [figure
-
].
2B
PLACING THE SPEAKERS
3
CONNECTING YOUR AMPLIFIER / RECEIVER
Note:
Do not let the bare speaker wires touch each other as this could damage the
speaker or amplifier / receiver, or both.
″
″
″
″
″
″
″
″
″
″
2A
a
A
B
C
D
A
B
C
D
A
B
A
B
C
D
A
B
C
D
A
B
C
D
A
B
A
B
C
D
A
B
C
D
A
B
C
D
A
B
A
B
C
D
