NS-AP2600
4
Attaching the non-skid pads
Place the satellite speakers on a sturdy, vibration-free surface, such as a well-built stand. Attach the included
non-skid pads to the bottom of the satellite speakers to prevent the speakers from slipping.
Wall mounting the satellite speakers
Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting
bracket on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the “key hole” opening.
SETTING UP THE SPEAKERS
WARNING
Each speaker weighs 1.6 lbs (0.7 kg). Do not mount the speakers on thin plywood or a wall with soft surface
material, since the screws may pull away from the surface and fall. This will damage the speakers and can
cause personal injury.
Do not mount the speakers on a wall with nails, adhesives, or any other unstable hardware. Long-term use
and vibrations may cause them to fall.
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor
molding.
Secure installation is the purchaser's responsibility.
Wall / wall support
When using speaker brackets to mount the speakers on a wall or celling, it is strongly recommended that
safety wire, which may be included with the bracket, be used between the speaker and the bracket to prevent
the speaker from falling.
Min
1”
3/8”
Tapping screw
(Available at
the hardware store)
4-1/8”
(105 mm)
2-3/8”
(60 mm)
You can also use the screw
holes on the back of the
speaker for installing the
speakers on commercially
available speaker brackets.
A screw with a diameter of
1/4” can be used.
(Hole depth: 9/32”)
Non-skid pads
