PERIODIC MAINTENANCE AND ADJUSTMENT
7-10
7
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil and clean
the oil strainer
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and drain bolt A to drain the oil
from the crankcase.
NOTICE:
When removing the engine oil
drain bolt, the O-ring, compres-
sion spring, and oil strainer will
fall out. Take care not to lose
these parts.
[ECA11001]
TIP
_
When only changing the engine oil, re-
move drain bolt A. When changing the
engine oil and cleaning the engine oil
strainer, remove drain bolt B also.
_
4. Clean the engine oil strainer with
solvent, and then check it for dam-
age and replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the engine oil strainer, com-
pression spring, O-ring and engine
oil drain bolt, and then tighten the
drain bolt to the specified torque.
TIP
_
Make sure that the O-ring is properly
seated.
_
7. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
1. Engine oil drain bolt A
2. Engine oil drain bolt B
2
1
ZAUU0385
1. Strainer
2. Compression spring
3. O-ring
ZAUU0056
Tightening torque:
Engine oil drain bolt A:
20 Nm (2.0 m·kgf, 15 ft·lbf)
Engine oil drain bolt B:
20 Nm (2.0 m·kgf, 15 ft·lbf)
Recommended engine oil:
See page 9-1.
Oil quantity:
0.80 L (0.85 US qt) (0.70 Imp.qt)
5P0_F8199_E1.book Page 10 Thursday, January 15, 2009 1:10 PM
