Yamaha MTM690, Руководство пользователя

Страница: 80 / 98

Perio d ic maintenance an d a d justment
6-33
6
3. Turn the key to “ON” and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
5. After the fuse is changed, place
the battery cover in the original
position, and then install the bolts.
6. Install the diagnostic connector by
pushing it downward.
7. Install the seat holder by installing
the bolts, and then tighten the
bolts to the specified torque.
EAU34386
Replacin g the hea d li g ht b ul b
This model is equipped with a halogen
bulb headlight. If the headlight bulb
burns out, replace it as follows.
NOTICE
ECA10651
Take care not to d ama g e the follow-
in g parts:

Hea d li g ht b ul b
Do not touch the g lass part of
the hea d li g ht b ul b to keep it free
from oil, otherwise the transpar-
ency of the
g lass, the luminosity
of the b ul b , an d the b ul b life will
b e a d versely affecte d . Thor-
ou g hly clean off any d irt an d fin-
g erprints on the hea d li g ht b ul b
usin g a cloth moistene d with al-
cohol or thinner.

Hea d li g ht lens
Do not affix any type of tinte d
film or stickers to the hea d li g ht
lens.
Do not use a hea
d li g ht b ul b of a
watta g e hi g her than specifie d .
1. Remove the headlight unit by re-
moving the bolts on each side.
2. Disconnect the headlight coupler,
and then remove the headlight
bulb cover.
Ti g htenin g torque:
Seat holder bolts:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
1. Do not touch the glass part of the bulb.
1. Bolt
ZAUM1381
1
UBU3E1E0.book Page 33 Monday, June 4, 2018 5:20 PM