Perio
d
ic maintenance an
d
a
d
justment
7-24
7
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both drive chain pullers are in the same
position for proper wheel alignment.
3. Tighten the axle nut, then the lock-
nuts to their specified torques.
4. Make sure that the drive chain
pullers are in the same position,
the drive chain slack is correct,
and the drive chain moves
smoothly.
5. Install the drive chain puller caps.
EAU23026
Cleanin
g
an
d
lu
b
ricatin
g
the
d
rive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
ECA10584
The
d
rive chain must
b
e lu
b
ricate
d
after washin
g
the motorcycle, ri
d
in
g
in the rain or ri
d
in
g
in wet areas.
1. Clean the drive chain with kero-
sene and a small soft brush.
NOTICE:
To prevent
d
ama
g
in
g
the O-rin
g
s,
d
o not clean the
d
rive chain with steam cleaners,
hi
g
h-pressure washers or inap-
propriate solvents.
[ECA11122]
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant.
NOTICE:
Do not use
en
g
ine oil or any other lu
b
ri-
cants for the
d
rive chain, as they
may contain su
b
stances that
coul
d
d
ama
g
e the O-rin
g
s.
[ECA11112]
1. Alignment marks
2. Drive chain puller
Ti
g
htenin
g
torques:
Axle nut:
57 N·m (5.7 kgf·m, 42 lb·ft)
Locknut:
16 N·m (1.6 kgf·m, 12 lb·ft)
1
2
UB5W10E0.book Page 24 Friday, March 27, 2020 12:34 PM
Содержание MT-03 2021
Страница 104: ...UB5W10E0 book Page 3 Friday March 27 2020 12 34 PM...
Страница 106: ...DIC183 PRINTED IN INDONESIA 2021 10...