Yamaha MOTIF-RACK, Руководство пользователя

Страница: 65 / 92

65
Refer
ence
Function List
42 L&R Gain L&R Gain Set the output gain of each jack. When this is set to a lower value, you can
control the fine volume by using the [VOLUME] Knob.
-
43 Asn1-4Gain Assignable Out 1-4 Gain
44 Coarse (Tune) Coarse Tune Determines the pitch setting in semitones (12: one octave). - *13
45 Fine (Tune) Fine Tune Determines the fine tuning. -
46 Random (Tune) Random Tune Randomly varies the pitch of the Element for each Note On message
received.
127...maximum pitch change
0...no pitch change.
-
47
TmVel
PEG Time Velocity
Sensitivity Determines the degree to which velocity affects the pitch change of the Pitch
EG. Positive settings will cause the pitch change to become faster for a large
Velocity value. Negative values will have the opposite effect. This affects only
the specified Segments.
- *21
48 Segmnt PEG Time Segment
Velocity Sensitivity
- *20
49 LvlVel PEG Level Velocity
Sensitivity Determines the sensitivity of the PEG Level (the width of the PEG change) to
velocity. The Curve parameter lets you select from five different preset
velocity curves (graphically indicated in the display), each determining how
velocity affects the Pitch EG.
- *21
50 CrvVel Velocity Sensitivity Curve
- *54
51 PitchVelSns
(VelSns) Pitch Velocity Sensitivity Determines the sensitivity of the PEG Level (the degree of the PEG change) to
velocity.
-
52 (PEG) TIME PEG Time Determines the transition in pitch from the moment a Note On message is
received to the point at which the sound stops.
26 53 (PEG) LEVEL PEG Level
54
(PEG) Depth
PEG Depth
55 FlwSns Pitch Key Follow Sensitivity Determines the sensitivity of the Key Follow effect (the interval of adjacent
notes). At +100, adjacent notes are pitched one semitone (100 cents) apart.
At 0, all notes are the same pitch (for the percussion sounds, etc.). At +50,
one octave is stretched out over twenty-four notes. For negative values, the
settings are reversed.
- *22
56 CntrKy Pitch Key Follow Center
Key Determines the basic pitch (note number) used by the PitchSens parameter
(above). The note number in this setting is the same pitch as normal (100%).
- *22
57 FlwSns PEG Time Key Follow
Sensitivity Determines the sensitivity of the PEG time (the speed of the PEG change) to
velocity.
- *22
58 CntrKy PEG Time Key Follow
Center Key Determines the basic pitch (note number) used by the EGTimeSens
parameter (above). When the center note is played, the PEG time behaves
according to its actual settings. For other notes, the speed varies in
proportion to the key played and its interval away from the center key.
- *22
59 Bank Arpeggio Type Bank Determines the Arpeggio bank.
pre1: preset 1, pre2: preset 2
53
60
Type
Arpeggio Type Determines the Arpeggio type. The two-letter prefix before the name
indicates the general Arpeggio category.
54 *27
61 Tempo Arpeggio Tempo Determines the Arpeggio Tempo. When MIDI sync set in the Utility mode is
turned on, “MIDI” is displayed here and cannot be set.
54
62 Switch
(ArpSwitch) Arpeggio Switch Determines whether Arpeggio is on or off.
54 *23
63 Hold Arpeggio Hold Determines whether Arpeggio playback is “held” or not. When set to “on,” the
Arpeggio cycles automatically, even if a Note Off message is received, and it
continues to cycle until the next Note On message is received.
- *24
64 KeyMode Arpeggio Key Mode Determines how the Arpeggio plays back when receiving a Note On
message.
-
*25
*26
*27
65 VelMode Arpeggio Velocity Mode Determines the playback velocity of the Arpeggio, or how it responds to the
received velocity value.
- *28
66
NoteLimit
Arpeggio Note Limit Low/
High Determines the lowest and highest notes in the Arpeggio’s note range.
54 *29
67 VelLimit Arpeggio Velocity Limit
Low/High Determines the lowest and highest velocity in the Arpeggio’s velocity range.
54 *9
Ref.
#
Display Parameter Name Explanation
Related
Page