7
ME2000
ENGLISH
Install the ME2000 Expansion Board and the Battery
1.
Disconnect the 6 flat cables from the 4 white connectors and 2 black connectors on the CPU
board.
●
To disconnect from white connectors: Pull out the connector latch as shown in the illustra-
tion, and then pull the cable out.
●
To disconnect from the black connectors: Grasp the top connector and pull off.
2.
Remove the 5 screws holding the CPU board in place, and remove the CPU board.
3.
Set the ME2000 expansion board into position, and fasten it into place with 5 screws (the 5
screws you removed above, or the 5 screws included in the kit).
4.
Reconnect the flat cables.
●
To reconnect to each white connector: Insert so that the red line on the cable is aligned with
the
▼
mark on the connector, and then push the latch down to secure it.
●
To reconnect to each black connector: Insert so that the blue line on the cable is aligned
with the
▼
mark on the connector.
When installing the expansion board, you can use either these 5 screws or else the 5 screws included
in the kit. If you reuse these original screws, you will not need the screws in the kit.
CPU
<Top View>
5 Screws
Lithium Battery
Flat Cable
Latch
Flat Cable
