background image

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four
points, and can be removed if desired. To remove the
cover, hold on to both sides and slowly pull straight
away from the speaker. To reattach, line up the four
pegs on the inside surface of the cover with the four
corresponding holes on the speaker and push gently.

Notes

When the cover is removed, take care not to touch
the speaker units with your hands or to exert
excessive force with tools.

This bass-reflex type speaker has an opening on the
front side.
Be careful not to obstruct the opening or put some
objects into it. If doing so, the sound will be
unnatural or it may cause damage to the speaker
and/or amplifier.

Built-in speaker protector
This speaker system incorporates a speaker
protector which protects the speakers from
excessive input. Once an excessive input is
applied to the speakers, the protector functions
and cuts out sound output from the speakers. If it
occurs, decrease the volume on the amplifier.
After several seconds, the protector stops
automatically and sound output revives.

SPECIFICATIONS

Type ......................2 way bass-reflex speaker system

Magnetic-shielding type (EIAJ)

Speaker Unit..................18 cm cone woofer (JA1824)

5 cm cone tweeter (JA05S2)

Input Terminal .............................................Push-type
Nominal Impedance.........................................6 ohms
Frequency Response ...........50 Hz – 20 kHz (–15 dB)
Nominal Input Power..........................................100W
Maximum Input Power .......................................200W
Sensitivity ...................................................91 dB/w/m
Dimensions (WxHxD)..................355 x 235 x 242 mm

(14” x 9-

1

/

4

” x 9-

1

/

2

”)

Weight.......................................5.8 kg (12 lbs. 12 oz.)

* Specifications subject to change without notice due

to product improvements.

* Care should be taken not to exceed the input power

values noted above.

This speaker system is designed for use in a side
long way.

Note
Though this speaker system is a magnetic shielding
type, there may be an influence on TV picture
according to the type of TV or the placement of the
speakers.  In such a case, place the speakers apart
from the TV so that there is no influence on TV
picture.

You can also use the screw holes on top of the
speaker for installing the speakers on the wall or the
ceiling by using commercially available mounting
brackets.

Opening

Right speaker

Front cover

Peg

Hole

A screw with a diameter of 5 mm and
a pitch of 0.8 mm can be used. 
(Depth of hole : 8 mm)

60 mm

110 mm

PLACING THE  SPEAKER

WARNING

The required length of a screw differs depending on
the mounting bracket to be used. Select a screw
which is suitable for use with the mounting bracket
and can be fully inserted into the hole on the
speaker.

Each speaker weigh 5.8 kg (12 lbs. 12 oz.). Do not
attach them to thin plywoods or soft wall surface
materials, as the screws may tear free from flimsy
surfaces, causing the speakers to fall and be
damaged, or result in personal injury.

Do not fasten the speakers to walls with nails,
adhesives, or other unsound hardware. Long-term
use and vibrations may cause them to pull free.

To avoid accidents resulting from tripping over loose
speaker cables, fix these to the wall along with the
speakers.

VV30820

Left speaker (A)

Right speaker (B)

Отзывы: