(6)-1
English
PRECAUTIONS
PLEASE READ CAREFULLY BEFORE PROCEEDING
* Please keep this manual in a safe place for future reference.
CAUTION
Always follow the basic precautions listed below to avoid the possibility of physical injury to you or
others, or damage to the device or other property. These precautions include, but are not limited to, the
following:
• If you use a stand, make sure to observe the following
precautions in order to avoid toppling the device or causing
damage to the internal components.
- Check the stand’s specifications and make sure that it is
sturdy enough to support the weight of the speaker.
- Mount only one speaker on each speaker stand.
- Use the supplied screws if included.
- Tighten fastening screws securely.
- Use the speaker stands with their legs fully opened.
- Use the stand at a height of less than 140cm.
- Add weight such as sand bags around the stand legs to
prevent them from falling over.
- Remove the speakers from the stands before moving the
stands or adjusting their height.
- Limit the number of people around the placed stand.
We recommend using the speaker stands manufactured by
Ultimate Systems (sold separately) to support the speakers.
• Always consult qualified Yamaha service personnel if the
device installation requires construction work, and make
sure to observe the following precautions.
- Choose mounting hardware and an installation location that
can support the weight of the device.
- Avoid locations that are exposed to constant vibration.
- Make sure to use the specified hardware.
- Inspect the device periodically.
• Before moving the device, remove all connected cables.
• Do not expose the device to excessive dust or vibrations, or
extreme cold or heat (such as in direct sunlight, near a
heater, or in a car during the day) to prevent the possibility of
panel disfiguration or damage to the internal components.
• Do not place the device in an unstable position where it
might accidentally fall over.
• Before connecting the device to other devices, turn off the
power for all devices. Before turning the power on or off for
all devices, set all volume levels to minimum.
• Use only speaker cables for connecting speakers to the
speaker jacks. Use of other types of cables may result in fire.
• When choosing a power amplifier to use with your speakers,
make sure that its power output matches the speakers’
power capacity (refer to the Specifications on page 14).
Even if the amplifier’s power output is lower than the
speakers’ power capacity, the speakers may be damaged
when clipping of a high input signal occurs. The following
may cause damage to speakers:
- Feedback caused when using a microphone.
- Continuous high sound pressure level produced by electronic
instruments.
- Continuous high-power output of distorted signals.
- Popping noises caused by turning on equipment, or by
connecting or disconnecting system components while the
amplifier is turned on.
• When turning on the AC power in your audio system, always
turn on the power amplifier LAST, to avoid speaker damage.
When turning the power off, the power amplifier should be
turned off FIRST for the same reason.
• Do not operate this device at high volume levels or at a level
that is uncomfortable, since it is capable of producing sound
levels that could cause permanent hearing loss. If you
experience any discomfort or ringing in the ears, or suspect
an hearing loss, you should consult an audiologist.
* Illustrations herein are for explanatory purposes only, and
may not match actual appearance during operation.
* Company names and product names herein are trademarks
or registered trademarks of their respective companies.
For details on signal processor settings when driving speakers
with the use of multiple power amplifiers, please refer to the
web site below.
Yamaha Pro Audio global web site
http://www.yamahaproaudio.com/
Location
Yamaha cannot be held responsible for damage caused
by improper use or modifications to the device.
Connections
Handling caution
