48
Setting the Manufacturer Code
You can set the code for the manufacturer of your
component after pressing the component selector buttons
other than AMP(TUNER).
1
Turn on your component to be used.
2
Press one of the
component selector
buttons which
corresponds to the
component to be
controlled.
3
Press both VOLUME
buttons (
u
/
d
) at the same
time for about four
seconds.
The indicator flashes twice.
4
Use the numeric buttons to
enter the four-digit
manufacturer code for the
component to be used.
Make sure that the
indicator flashes twice.
If the indicator does not flash,
repeat step 3 and re-enter the
code.
5
Press POWER (or any other button) on the
remote control to check if you have set the
code correctly.
If your component cannot be
controlled with the remote
control, try setting another code
for the same manufacturer.
Notes
• You can set only one code for one mode.
• In the DVD/LD and DVD MENU modes:
Be sure to press DVD/LD on the component selector before
entering the code for the DVD/LD player. You cannot set the code
for a DVD player after pressing DVD MENU on the component
selector. The code set in the DVD/LD mode is also
simultaneously set in the DVD MENU mode.
• If your component does not respond to any of the codes listed for
the manufacturer, use the original remote control supplied with
your component.
■
To use a second (and third) VCR
You can control a second (and third) VCR in the CBL/SAT
and DVD MENU modes if a cable TV or satellite tuner, or
DVD player is not being used.
Note
• In order to set a second (and third) VCR in the DVD MENU
mode, it is necessary to first set up the code for an LD player in
the DVD/LD mode.
1
Turn on the VCR to be used.
2
Press CBL/SAT or DVD
MENU on the component
selector.
3
Press both VOLUME
buttons (
u
/
d
) at the same
time for about four
seconds.
The indicator flashes twice.
4
Use the numeric buttons to
enter the four-digit code
for the second (and third)
VCR. Make sure that the
indicator flashes twice.
If the indicator does not flash,
repeat step 3 and re-enter the
code.
5
Press POWER (or any other button) on the
remote control to check if you have set the
code correctly.
If the VCR cannot be controlled
with the remote control, try
setting another code for the
same manufacturer.
PRESET REMOTE CONTROL
0108V520RDS43-49_EN
1/31/1, 4:24 PM
48