16
RX-V596/HTR-5250/RX-V596RDS
No.6 DISPLAY CHECK
Check program for FL display. The display status will change as follows with sub-menu operation.
signal route is the same as "2. EFFECT OFF" of "No. 4 PRO LOGIC".
A defect of the FL drive port and FL display segments can be detected by using "All segments turn off" and "All
segments turn on".
A short-circuit between adjacent segments can be detected by using "Alternate segments turn on" (lattice form).
No.7 MANUAL TEST
By using the noise generator built into the DSP, a test noise outputs to the channel specified by the sub-menu.
No.8 FACTORY PRESET
The initialization of the back-up RAM, which contains, the DSP program, set menu contents, etc. is reserved
or inhibited. Signal route is the same as "2. EFFECT OFF" of "No.4 PRO LOGIC".
1. INHIBITED:
Inhibits initialization of the back-up RAM.
Specify this option protect user set values.
2. RESERVED: Reserve to initialization of the back-up RAM.
(The RAM is actually initialized when power
is turned on next time.) Specify this option
at the factory preset or to reset the RAM.
For the contents of the initialization, see page 20.
The protection data is also reset.
6
V F D C H C K
7
T E S T A L L
7
T E S T M A I N R
7
T E S T
L F E
7
T E S T M A I N L
7
T E S T R E A R R
7
T E S T C E N T E R
7
T E S T R E A R L
Initial display
All segments turn off
All segments turn on (see page 35)
(lattice form)
Alternate segments turn on
Software Release date display
Caution :
Before setting to the PRESET RESERVED, write down the existing preset memory contents of the Tuner in
a table as shown below. (This is because setting to the PRESET RESERVED will cause the memory contents
to be as factory set, i.e., all the preset memory by the user will be erased.)
Page
P1
P2
P3
P4
P5
P6
P7
P8
A
B
C
D
E
8 P R E S E T
I N H I
8 P R E S E T R S R V D
Содержание HTR-5250
Страница 54: ...RX V596 HTR 5250 RX V596RDS ...