CONFIGURATIONS
➤
Configuring the system settings (ADVANCED SETUP menu)
En
80
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press
z
(power).
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press
z
(power) to set the unit to standby mode and turn it on again.
The new settings take effect.
ADVANCED SETUP menu items
Changing the speaker impedance setting (SP IMP.)
(U.S.A. model only)
Change the unit’s speaker impedance settings depending on the impedance of the
speakers connected.
Settings
Selecting the remote control ID (REMOTE ID)
Change the unit’s remote control ID so that it matches the remote control’s ID (default:
ID1). When using multiple Yamaha AV receivers, you can set each remote control with a
unique remote control ID for its corresponding receiver.
Settings
ID1 (default), ID2
■
Changing the remote control ID of the remote control
Perform each of the following steps within 1 minute. Otherwise, the setting will be
automatically canceled.
1
Press CODE SET on the remote control using a pointed object, such as the tip of a
ballpoint pen.
2
Press SOURCE/RECEIVER.
3
Use the numeric keys to enter “5019” (ID1) or “5020” (ID2).
Once the remote control ID is registered successfully, SOURCE/RECEIVER blinks twice.
If it blinks six times, registration failed. Repeat from Step 1.
• The registered remote control codes (p.82) are not cleared even if you change the remote control ID.
Configuring the system settings
(ADVANCED SETUP menu)
Item
Function
Page
SP IMP.
(U.S.A. model only)
Changes the speaker impedance setting.
REMOTE ID
Selects the unit’s remote control ID.
TV FORMAT
Switches the video signal type of HDMI output.
INIT
Restores the default settings.
UPDATE
Updates the firmware.
VERSION
Checks the version of firmware currently installed on the unit.
z
(power)
STRAIGHT
PROGRAM
6
Ω
MIN
Select this option when you connect 6-ohm speakers to the unit. You
can also use 4-ohm speakers as the front speakers.
8
Ω
MIN (default)
Select this option when you connect 8-ohm or higher speakers to the
unit.
SPIMP.8MIN
REMOTEIDID1
Содержание HTR-4065
Страница 1: ...AV Receiver Owner s Manual English Read the supplied booklet Safety Brochure before using the unit ...
Страница 108: ... 2012 Yamaha Corporation YE162B0 EN ...
Страница 411: ...xviii ...
Страница 478: ...9 Ru Технические характеристики Printed in Indonesia WY61990 2011 Yamaha Corporation ...