5
Installation
■
Hardware
The following parts are provided for installation
of the controller unit. Please make sure you have
all the parts.
•
Self-tapping round-head screw (3x16mm)
........................... 1
•
Double-sided adhesive tape .................... 3
•
Re-usable double-sided adhesive pads
(transparent). ..... 3
•
Spacer (double-sided adhesive). ............ 6
•
Velcro fastener ......................................... 1
•
Bracket ..................................................... 1
•
Suction cups ............................................ 3
Controller
Pickup
Multi-pin cable
GUITAR
MIX
SYNTH
UP
DOWN
VOL
Direct guitar’s cable
■
Installation Procedure
1. Determine the optimum
location for installation.
Normally, the controller should be attached
somewhere behind the guitar’s bridge, as shown in
the illustration. It should be accessible, but it
should not interfere with your playing or any of the
guitars controls or adjustments. Consider the
following points carefully when deciding on the
best location to install the controller:
•
The controller and pickup cable should not get
in the way of your picking-hand at any time.
Make sure the location you choose will not
affect your playing style.
•
The controller should not block or hamper
access to any of the guitar’s controls: tone,
volume, bridge adjustments (especially watch
out for intonation/saddle screws accessed from
the rear of the bridge).
•
The controller must be well within reach of
both the pickup cable (when the pickup is in its
final installed position) and the direct guitar
cable
•
Neither the controller unit itself nor any of the
connected cable plugs should extend beyond the
body of the guitar to prevent accidental damage.
