Yamaha FJR, Руководство пользователя

Страница: 24 / 100

INSTRUMENT AND CONTROL FUNCTIONS
3-10
3
The average fuel consumption display
can be set to either “AV _ _._ km/L” or
“AV _ _._ L/100 km”.
When the average fuel consumption
mode is selected, the display flashes
for five seconds, and then, depending
on the unit set, “AV _ _._ km/L” (aver-
age distance that can be traveled using
1.0 L of fuel) or “AV _ _._ L/100 km” (av-
erage amount of fuel necessary to trav-
el 100 km) is displayed.
To reset the average fuel consumption
display, push the “RESET” button to se-
lect the mode again, and then push the
“RESET” button for 1 second while the
display is flashing.
NOTE:
● To switch between the two aver-
age fuel consumption displays,
push the “RESET” button for 1
second when either display is
shown.
●
After resetting an average fuel
consumption display, “_ _._” will
be shown for that display until the
vehicle has traveled 1 km.
CAUTION:
ECA15472
If there is a malfunction, “– –.–” will
be displayed. Have a Yamaha dealer
check the vehicle.
Ambient temperature, instanta-
neous fuel consumption and aver-
age fuel consumption modes (for
the UK only)
Push the “RESET” button to switch the
display between the ambient tempera-
ture mode and the fuel consumption
modes in the following order:
Air
→
MPG
→
AV _ _._ MPG
→
Air
Ambient temperature mode
This display shows the ambient tem-
perature from –9 °C to 50 °C in 1 °C in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
NOTE:
●
If the ambient temperature falls be-
low –9 °C, a lower temperature
than –9 °C will not be displayed.
● If the ambient temperature climbs
above 50 °C, a higher temperature
than 50 °C will not be displayed.
● The accuracy of the temperature
reading may be affected when
riding slowly [approximately under
1. Ambient temperature/instantaneous fuel
consumption/average fuel consumption
2. “SELECT” button
3. “RESET” button
1. Ambient temperature
U5P5E0E0.book Page 10 Tuesday, March 21, 2006 12:00 PM