INSTRUMENT AND CONTROL FUNCTIONS
4-17
4
Ri
g
ht
EAU54201
Dimmer/Pass switch “
/
/PASS”
Set this switch to “
” for the high
beam and to “
” for the low beam.
To flash the high beam, push the pass
side “PASS” of the switch while the
headlights are on low beam.
EAU12461
Turn si
g
nal switch “
/
”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “
”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “
”
Press this switch to sound the horn.
EAU54211
Start/En
g
ine stop switch “
/
/
”
To crank the engine with the starter,
set this switch to “
”, and then push
the “
” side of the switch. See page
6-1 for starting instructions prior to
starting the engine.
Set this switch to “
” to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAU42342
The engine trouble warning light and
ABS warning light may come on when
the key is turned to “ON” and the start
switch is pushed, but this does not in-
dicate a malfunction.
EAU12735
Hazar
d
switch “
”
With the key in the “ON” or “
” posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
ECA10062
Do not use the hazar
d
li
g
hts for an
exten
d
e
d
len
g
th of time with the en-
g
ine not runnin
g
, otherwise the
b
at-
tery may
d
ischar
g
e.
EAU59010
Menu switch “MENU”
This switch is used to perform selec-
tions in the setting mode display of the
multi-function meter unit.
See “Multi-function meter unit” on
page 4-4 for detailed information.
1. Start/Engine stop switch “
/
/
”
2. Drive mode switch “MODE”
3. Hazard switch “
”
1
2
3
U2SC10E0.book Page 17 Thursday, September 4, 2014 11:04 AM
