Yamaha Fazer FZ8-SA, Руководство по обслуживанию

Страница: 293 / 610

VALVES AND VALVE SPRINGS
5-28
EAS24300
CHECKING THE VALVE SEATS
The following procedure applies to all of the
valves and valve seats.
1. Eliminate:
• Carbon deposits
(from the valve face and valve seat)
2. Check:
• Valve seat
Pitting/wear
→
Replace the cylinder
head.
3. Measure:
• Valve seat width “a”
Out of specification
→
Replace the cylin-
der head.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Apply Mechanic’s blueing dye (Dykem) “b”
onto the valve face.
b. Install the valve into the cylinder head.
c. Press the valve through the valve guide
and onto the valve seat to make a clear
impression.
d. Measure the valve seat width.
TIP
Where the valve seat and valve face contacted
one another, the blueing will have been
removed.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4. Lap:
• Valve face
• Valve seat
TIP
After replacing the cylinder head or replacing
the valve and valve guide, the valve seat and
valve face should be lapped.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Apply a coarse lapping compound “a” to
the valve face.
ECA13790
Do not let the lapping compound enter the
gap between the valve stem and the valve
guide.
b. Apply molybdenum disulfide oil onto the
valve stem.
c. Install the valve into the cylinder head.
d. Turn the valve until the valve face and valve
seat are evenly polished, then clean off all
of the lapping compound.
TIP
For the best lapping results, lightly tap the
valve seat while rotating the valve back and
forth between your hands.
Valve seat width
Valve seat width (intake)
0.90–1.10 mm (0.0354–0.0433
in)
Limit
1.60 mm (0.06 in)
Valve seat width (exhaust)
0.90–1.10 mm (0.0354–0.0433
in)
Limit
1.60 mm (0.06 in)