Yamaha F8F, Руководство пользователя

Страница: 41 / 98

Operation
35

Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.

Look for loose or damaged connections of
the throttle and shift cables.
EMU36484
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU27168
Engine oil
(1) Put the outboard motor in an upright po-
sition (not tilted).
NOTICE:
If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01791]
(2) Remove oil dipstick and wipe it clean.
(3) Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
(4) Check the oil level using the dipstick to
be sure the level falls between the upper
and lower marks. Fill with oil if it is below
the lower mark, or drain to the specified
level if it is above the upper mark.
EMU40412
Outboard motor

Check that the outboard motor is mounted
properly and check the outboard motor
mounting bolts for looseness.

Check the propeller for damage.

Check for engine oil leaks.
1. Clip
2. Engine shut-off cord (lanyard)
ZMU06873
1
2
1. Oil dipstick
1. Oil dipstick
2. Upper mark
3. Lower mark
1
3 2 1
U6FW76E0.book Page 35 Tuesday, November 23, 2021 7:37 AM