Yamaha F8A, Руководство пользователя

Страница: 64 / 90

Maintenance
the attitude shown when transporting
and storing it. If storing or transporting
the outboard motor on its side (not up-
right), put it on a cushion after draining
the engine oil.

Do not place the outboard motor on its
side before the cooling water has
drained from it completely, otherwise
water may enter the cylinder through the
exhaust port and cause engine trouble.

Store the outboard motor in a dry, well-
ventilated place, not in direct sunlight.
Procedure
Flushing in a test tank
NOTICE
Before starting the engine, make sure to
supply water to the cooling water passag-
es. Otherwise, the engine could overheat
TIP: and be damaged.
When transporting the outboard motor in a
horizontal position, place a towel or some-
thing similar under the outboard motor to pro-
tect it from damage.
1. Dismount the outboard motor from the
boat. For further details, see page 56.
2. Wash the outboard motor body using
fresh water. NOTICE: Do not spray wa-
Storing outboard motor ter into the air intake.
[ECM01840]
For further
When storing your Outboards outboard motor information, see page 60.
for prolonged periods of time (2 months or
3. Disconnect the fuel line from the out-
longer), several important procedures must
board motor.
be performed to prevent excessive damage.
4. Remove the engine top cowling and si-
It is advisable to have your outboard motor lencer cover/cap, if equipped. Remove
serviced by an authorized Outboards dealer pri- the propeller. For further details, see
or to storage. However, you, the owner, with a page 71.
minimum of tools, can perform the following 5. Position the outboard motor on a water
procedures. tank. For further details, see page 29.
6. Fill the tank with fresh water until the anti-
NOTICE
cavitation plate is immersed in water.

To prevent problems which can be
NOTICE: If the fresh water level is be-
caused by oil entering the cylinder from
low the level of the anti-cavitation
the sump, keep the outboard motor in
58