Operation
79
TIP:
●
When the main switch is turned to “
”
(start) with the clip removed from the en-
gine shut-off switch, the buzzer will sound.
●
Except the single type, if the clip is not in-
stalled to the engine shut off switch, the
buzzer will sound when the Start/Stop but-
ton is pressed.
●
Except the single type, if one of the en-
gines has started, it can be stopped by
pressing the Start/Stop button on the All
start/Stop panel.
EMU42170
Procedure for dual station models (main
station)
1. If equipped with the Yamaha Security
System: If the lock mode of the Yamaha
Security System is selected, use the re-
mote control transmitter to select the un-
lock mode. Short beep will sound twice
when unlocking the Yamaha Security
System. For further information, see
page 33.
TIP:
●
If you lost track of the current security
mode, press the lock or unlock button to
reset the security system.
●
The signal transmission range of the re-
mote control transmitter varies depending
on the mounting position of the receiver.
To operate the Yamaha Security System
correctly, use the transmitter as close as
possible from the receiver.
●
If Yamaha Security System may not oper-
ate correctly, repeat the activating proce-
dure once again.
2. Place the control lever in “ ” (neutral).
TIP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
3. Turn the main switch “
” (on) to make
sure that the digital electronic control-ac-
tive indicator lights. The engine can not
be started when the digital electronic
control-alert indicator lights.
4. The procedure until starting the engine
is the same as that of the single station
models.
NOTICE:
Never turn the main
switch to “
” (start) while the en-
gine is running. Do not keep the start-
er motor turning for more than 5
ZMU07150
ZMU05829
N
6AW-9-18.book 79 ページ ２０１０年３月２２日 月曜日 午前１１時３５分
©
2019 Yamaha Motor Corporation, U.S.A.
