Yamaha F200G, Руководство пользователя

Страница: 97 / 104

Trouble Recovery
91
4. Have a Yamaha dealer check the out-
board motor before operating it again.
EMU29454
Running single engine (twin engines)
When using only one engine in an emergen-
cy, be sure to keep the unused one tilted up
and operate the other engine at low speed.
NOTICE
ECM00371
If the boat is operated with one engine in
the water but not running, water may run
into the exhaust pipe due to wave action,
causing engine trouble.
TIP:
When you are maneuvering at low speed,
such as near a dock, it is recommended that
both engines be running with one in neutral
gear if possible.
EMU41882
Replacing fuse
WARNING
EWM00632
Substituting an incorrect fuse or a piece of
wire could allow excessive current flow.
This could cause electric system damage
and a fire hazard.
If a fuse has blown, replace the fuse accord-
ing to the following procedure.
1.
Turn the main switch to the “ ” (off)
position.
2. Remove the fuse box cover.
3. When replacing the main fuse or isolater
fuse, remove the screws, and then re-
move the fuse. Install the spare fuse, and
then tighten the screws.
4. When replacing a fuse other than the
main fuse or isolater fuse, remove the
fuse using the fuse puller. Install a spare
fuse of the proper amperage.
1. Fuse box cover
2. Spare fuse (10 A, 15 A, 20 A, 30 A, 60 A)
3. Fuse puller
1. Fuel feed pump fuse (10 A)
2. Main switch / PTT switch fuse (20 A)
3. Shift actuator fuse (15 A)
4. Starting switch fuse (30 A)
5. Ignition coil / Fuel injector / Variable cam-
shaft timing / Engine ECM (Electronic con-
trol module) fuse (30 A)
6. Electric throttle valve fuse (10 A)
7. Fuel pump fuse (15 A)
8. Main fuse (60 A)
9. Isolator fuse (60 A)
10.Screw
2
1
3
2
ZMU07786
1
8
2
4
5
6
7
9
10
10
3
ZMU07995
U6DV72E0.book Page 91 Friday, December 19, 2014 3:38 PM