Yamaha F200B, Руководство по обслуживанию

Страница: 555 / 579

10-14
10
È
F200B and FL200B
É
F250G and FL250G
TIP:
Apply grease to the grease nipple until it
flows from the bushings
a
.
2. Apply low temperature resistant grease
to the specified lubrication points.
3. Apply corrosion resistant grease to the
specified lubrication points.
Checking the PCV
Check the PCV. See “Checking the PCV” (9-
20).
Checking the PTT fluid level
Never get under the outboard motor while
it is tilted.
Do not reuse an O-ring, always replace it
with a new one.
1. Fully tilt the outboard motor up, and then
support it using the tilt stop lever
1
.
2. Remove the reservoir cap 2 and O-ring
3 , and then check the fluid level in the
reservoir. WARNING! Before removing
the reservoir cap, make sure that the
PTT rams are fully extended. Other-
wise, fluid could be expelled forcefully
from the unit due to internal pressure.
TIP:
If the fluid is at the proper level, a small
amount of fluid should flow out of the filler
hole when the reservoir cap is removed.
3. If the fluid is below the proper level, add
the recommended fluid.
A A
É
D
Recommended PTT fluid: ATF Dexron II
1
2 3
General periodic maintenance