Operation
63
gine is running. Do not keep the start-
er motor turning for more than 5
seconds. If the starter motor is turned
continuously for more than 5 seconds,
the battery will be quickly discharged,
thus making it impossible to start the
engine. The starter can also be dam-
aged. If the engine will not start after 5
seconds of cranking, return the main
switch to “
” (on), wait 10 seconds,
then crank the engine again.
[ECM00193]
EMU36511
Checks after starting engine
EMU36524
Cooling water
Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the pilot hole indicates that the
water pump is pumping water through the
cooling water passages. If the cooling water
passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
NOTICE
ECM01811
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check whether
the cooling water inlet on the lower case
or the cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
EMU27671
Warming up engine
EMU30039
Electric start models
1.
After starting the engine, allow it to idle
for 3 minutes to warm up to provide max-
imum operating performance and accel-
eration.
NOTICE:
Failure to do so will
shorten engine life.
[ECM04550]
2.
Be sure the low oil pressure-alert indica-
tor remains off after starting the engine.
NOTICE:
If the low oil pressure-alert
indicator blinks after the engine starts,
stop the engine. Otherwise, serious
engine damage could occur. Check
the oil level and add engine oil if nec-
essary. Consult your Yamaha dealer if
the cause for the low oil pressure alert
cannot be found.
[ECM01832]
EMU36532
Checks after engine warm up
EMU36542
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU40461
Stop switches
Perform the following procedure to check
that the main switch and engine shut-off
switch operate properly.
1. Cooling water pilot hole
1
ZMU07766
U63P3GE0.book Page 63 Monday, December 15, 2014 2:02 PM
©
2019 Yamaha Motor Corporation, U.S.A.
Содержание F150D1
Страница 112: ...U63P3GE0 book Page 106 Monday December 15 2014 2 02 PM 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A ...
Страница 131: ...ZMU01708 Informations de sécurité 9 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A ...
Страница 231: ...Informations pour le consommateur Pour l Amérique du Nord 109 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A ...
Страница 236: ... 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A ...