Panel Operations
11
q
UNIT ID, LABEL
Shows the UNIT ID and label assigned so that DZR-D or DXS-XLF-D series devices on
the Dante network can be recognized. When the DANTE MODE
is set to
Quick Config, this will show as “QC,” and the name of the selected TF series output
channel. Go to the DANTE SETUP screen to configure and display Dante settings.
w
Input Meter
Shows analog input signal levels. On Dante models this will appear as ANA.
Clipped input signals will light up at the top when clipping occurs.
e
Input Meter (DNT)
Shows digital input signal (Dante) levels. Clipped input signals will light up at the top
when clipping occurs.
r
MASTER Level
Sets and displays output levels. (Unit: dB)
t
SP Output Meter
Shows output levels. Sigma (
) clipping at the top will light up when clipping occurs
within a channel.
y
Protection (THERMAL, MUTED)
Appears when safeguard functions have been activated. “THERMAL” is shown when a
high temperature is detected in the amplifier, and output levels are reduced. If operat-
ing conditions further deteriorate, this will change to “MUTED,” and the output signal
will be muted.
u
PRESET
Shows the preset number and title of the set preset. This enables you to save, load and
change audio settings.
(E symbol) will appear when parameters have been
changed.
i
HPF
Sets and displays the high-pass filter frequency.
LPF
Sets and displays the low-pass filter frequency and the POLARITY. An indication Ø will
appear when POLARITY is set to INVERTED.
o
D-CONTOUR
Sets and display the D-CONTOUR mode.
D-XSUB
Sets and displays the D-XSUB mode.
!0
EQ
Shows whether the equalizer (6 Band EQ) is on or off. You can configure EQ settings
while checking the frequency response characteristics.
!1
DELAY
Sets and displays the delay.
!2
CARDIOID
Sets and displays the cardioid mode.
!3
ROUTER
Configures the routing of the audio signal.
!4
UTILITY
Sets and displays the device operating settings.
•
PANEL SETUP:
Sets the brightness and contrast of the display, and automatic turn
off settings for the display and indicators.
•
PANEL LOCK:
Configures panel lock settings, and saves and loads PIN codes.
•
DEVICE BACKUP:
Saves and loads settings data.
•
DANTE SETUP
:
Sets and displays Dante-related settings.
•
NETWORK
:
Sets and displays network-related settings.
•
DEVICE INFORMATION:
Shows device status, and device-specific information.
•
INITIALIZE:
Resets to the default settings.
•
LOG:
Shows recorded logs and saves logs to a USB flash drive.
•
UPDATE FIRMWARE:
Updates the firmware for the device, and the Dante module.
Dante model
Dante model
Full range
Subwoofer
Full range
Subwoofer
Subwoofer
Dante model
Dante model
