Yamaha DX100, Руководство пользователя

Страница: 30 / 61

content of the note changes (the timbre changes) from the time the note is initiated
to the time it decays.
Each of the 4 operators available in DX100 can be programmed with its own en-
velope. The envelope applied to a carrier will, generally, contribute to the overall
volume envelope of the note, while an envelope applied to a modulator will con-
tribute to the timbre envelope of the note.
Here is a copy of the envelope diagram printed to the right of the algorithm diagrams
on the DX100 panel.
BASIC EG CURVE
This envelope diagram can be used as a guide in visualizing DX100 envelope settings
while you program or edit a voice.
Each envelope generator can be programmed with five different parameters: AT-
TACK RATE (AR), DECAY 1 RATE (D1R), DECAY 1 LEVEL (D1L), DECAY 2 RATE
(D2R), and RELEASE RATE. The RATE parameters determine how fast the envelope
moves from one level to the next. The term LEVEL is used rather than “volume”
because the envelope of the operator you’re working on could affect volume or
timbre, depending on whether it is a carrier or a modulator.
Any note begins at zero level when you press a key, then begins to approach
maximum EG level at a rate determined by the AR (Attack Rate) setting. The en-
velope may reach maximum level instantly, or it may take over 9 seconds depending
on the setting of AR.
When the envelope reaches maximum level, it immediately begins moving towards
the next level in the envelope–D1L (Decay 1 Level)–at a speed determined by the
setting of D1R (Decay 1 Rate).
The change from maximum EG level to D1R can be either a decrease in level or a
sustain at maximum level, depending on the values you choose for D1L.
After reaching D1L, the envelope then begins to decay toward zero level at a speed
determined by the setting of the D2R (Delay 2 Rate) parameter. If D2R is set to
0 (no decay), however, the note will be sustained at D1L for as long as you hold
the key. Now, when you release the key you have been holding, the envelope
will immediately begin to decay toward 0 level at a speed determined by RR (Release
Rate). In fact, at whatever point in the envelope you release the key, the envelope
will immediately begin moving toward 0 level at the set Release Rate. AR, D1R,
and D2R settings of 0 produce sustain at initial level, while an RR setting of 0
produces a slow decay. Thus ends the note envelope “history.”
28