DVD-S530/DV-S5550
DVD-S530/DV-S5550
14
In this example 23 is the hexidecimal code of the pressed
RC key. The user can leave the remote-control test by
pressing PLAY on the local keyboard of the DVD player.
The remote control test is successful if a code was
received before the user pressed the PLAY key. Pressing
the PLAY key, before pressing a key on the remote
control, gives an error in the remote control test (note that
the remote control test will also fail if a key on the remote
control was pressed but no code was received). The
remote control test does not check upon the contents of
the received code, that is it will not be checked if the
received code matches the key pressed. If desired, the
user can manually check this code by using a code-table
for the remote control key-codes.
RC Key id
Hexadecimal code
POWER
0C
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
0
0
RETURN/RESUME
83
CD TEXT/BIT RATE
EF
MENU
54
ON SCREEN
82
CURSOR UP
58
CURSOR DOWN
59
CURSOR LEFT
5A
CURSOR RIGHT
5B
OK/ENTER
5C
PREVIOUS
21
NEXT
20
STOP
31
PLAY
2C
PAUSE
30
SUBTITLE
4B
ANGLE
85
ZOOM
F7
AUDIO
4E
REPEAT
1D
REPEAT A-B
3B
SHUFFLE
1C
SCAN
2A
Fig. 12
After pressing PLAY, the result of the remote control test is
displayed on the local display of the DVD player as
follows:
Fig. 13
Or
Fig. 14
Pressing PLAY on the local keyboard again will proceed to
the next test.
3.5 P50 Loop-Back Test
For the P50 loop-back test, the user must first press a key
to decide if the test is to be performed.
The display will show the following message:
Fig. 15
If the user presses STOP, the P50 test will be skipped.
If the user presses OPEN/CLOSE, the P50 test is
performed and the result is displayed as follows:
Test successful:
Fig. 16
Test fails:
Fig. 17
Press the PLAY key to continue to the next text.
