REFERENCE SECTION
Drum Kit V
oice Edit Mode
46
[Voice3] VOICE3
Set the stereo panning and filter for each MIDI
note number (drum pad). If you have chosen a 2-
layered voice, you can also specify output
volume of each layer.
1
Note Number & Name
Choose a target MIDI note number. Each note
number has a specific note name (shown in the
LCD) as found in the [VOICE1] page.
❏
Settings
: 13C#-1 – 94A#5
2
Pan
Adjust the pan setting for the voice you have
chosen. This setting determines the stereo
positioning of the voice.
❏
Settings
: L64 – C – R63 (left to center to right)
3
Layer
Specify the output volume of each layer if you
have chosen a 2-layered voice. A value of “0” will
apply the same volume level (50:50) to each
layer. If the voice is not 2-layered, this parameter
is not editable.
❏
Settings
: -64 (100:0) – 0 (50:50) – +63 (0:100)
4
Filter
Adjust the filter setting for the voice you have
chosen. This low-pass filter that cuts the
frequencies higher than a specified point (cut-off
point) and passes the rest. By combining with the
“Q” parameter, you can use these parameters to
provide unique sonic characteristics to your
voice.
❏
Settings
: -64 – +63
5
Q
Adjust the Q (quality) factor around the cut-off
point. By boosting around the cut-off point, you
will adjust the curve portion as shown above,
and can give unique characteristics to your voice.
❏
Settings
: -64 – +63
[Voice3] Pan Layer Filter Q
49C# 2 R13 +63 +63 +63
1
4
5
3
2
Frequency
Frequency
Cut-off point
Blocked frequencies
Low-pass filter and frequencies
Q (Q curves)
Frequencies passed
by the filter
Level
Level
Q max.
Q min.
Содержание DTXTREME
Страница 1: ......
Страница 136: ...String Guitar Percussion Division Yamaha Corporation 2000 Yamaha Corporation Printed in Taiwan ...