Assembly Guide
20
Setup
DTX402K DTX432K DTX452K Owner’s Manual
Connecting the pads to the drum module
1.
Insert the mini plugs* at one end of the nine-channel snake cable into the correct trigger input jacks (SNARE to KICK/
PAD) on the drum module. (*: The smaller set of plugs.)
2.
Insert the nine-channel snake cable’s standard plugs* into the jacks in the corresponding pads. (*: The larger set of plugs.)
3.
Wrap the cables for the snare pads, the tom pads, and the cymbal/hi-hat pads around the cable clips to prevent them from
being pulled out.
4.
Using the cable bands, secure the cables to the kit rack at the
positions in the figure above.
Congratulations—You have finished assembling your electronic drum kit!
Here is a left-handed setup.
Please assemble the drum kit referring to the image.
The sticker on each of the snake cable’s plugs indicates the name of the corresponding pad.
For the kick pad KP65 in the DTX432K and DTX452K, use the OUT
>
DTX jack. No sound will be played when the PAD
>
IN jack is
used.
Excessive bending can damage the cables. Ensure, therefore, that they are not bent at an extreme angle when wrapped around the
clips.
Please ensure that the two joints in the figure below are used in different ways
from how they are used in the right-handed setup.
Right-handed • • • • • • • • • • • • • • • • Left-handed • • • • • • • • • • • • • • • • • •
Step 14
RIDE
SNR
HH
KICK
HHC
TOM3
TOM2 TOM1
CR
KICK
HHC
RIDE
SNR
HH
KICK
HHC
HH
CR
RIDE
TOM3
TOM2
TOM1
SNR
TOM2
TOM1
CR
TOM3
KICK
HHC
DTX402K
Trigger input jacks on the drum module
Nine-channel snake cable
NOTE
NOTE
NOTICE
Fully assembled drum kit (DTX452K shown)
NOTE