Yamaha CP4 Stage, Список данных

Страница: 19 / 43

CP4 STAGE/CP40 STAGE Data List
19
Effect Parameter List
Category – PHASER
• Tempo Phaser
Category – TREMOLO&ROTARY
• Auto Pan
• Tremolo
• Rotary Speaker
*3 This parameter cannot be controlled using the pitch bend wheel.
Category – DISTORTION
• Amp Simulator 1
• Amp Simulator 2
• Comp Distortion
No. Parameter Range Value Table No. Ctrl
1 LFO Speed 16th – 4thx16 5 – 29 14
2 LFO Depth 0 – 127 0 – 127
3 Phase Shift Offset 0 – 127 0 – 127
4 Feedback Level -63 – +63 1 – 127
5 —
6–9: Same as the parameters shaded in gray in Cross Delay on page 17.
10 Dry/Wet Balance D63>W – D=W – D<W63 1 – 127

11 Stage 4 – 22
(Chorus Block: 4 – 12) 4 – 22
4 – 12
12 Diffusion Mono, Stereo 0 – 1
13 —
14 —
15 —
16 —
No. Parameter Range Value Table No. Ctrl
1 LFO Speed 0.0Hz – 39.70Hz 0 – 127 1

2 L/R Depth 0 – 127 0 – 127
3 F/R Depth 0 – 127 0 – 127
4 Pan Direction L<>R, L>>R, L<<R,
L Turn, R Turn, L/R 0 – 5
5 LFO Wave 0 – 28 0 – 28
6–9: Same as the parameters shaded in gray in Cross Delay on page 17.
10 —
11 EQ Mid Frequency 100Hz – 10.0kHz 14 – 54 3
12 EQ Mid Gain -12dB – +12dB 52 – 76
13 EQ Mid Width 0.1 – 12.0 1 – 120
14 —
15 Input Mode Mono, Stereo 0 – 1
16 —
No. Parameter Range Value Table No. Ctrl
1 LFO Speed 0.0Hz – 39.70Hz 0 – 127 1

2 AM Depth 0 – 127 0 – 127
3 PM Depth 0 – 127 0 – 127
4 —
5 —
6–9: Same as the parameters shaded in gray in Cross Delay on page 17.
10 —
11 EQ Mid Frequency 100Hz – 10.0kHz 14 – 54 3
12 EQ Mid Gain -12dB – +12dB 52 – 76
13 EQ Mid Width 0.1 – 12.0 1 – 120
14 LFO Phase Difference -180deg – +180deg 4 – 124
15 Input Mode Mono, Stereo 0 – 1
16 —
No. Parameter Range Value Table No. Ctrl
1 Rotor Speed Slow 0.0Hz – 2.65Hz 0 – 63 1
2 Horn Speed Slow 0.0Hz – 2.65Hz 0 – 63 1
3 Rotor Speed Fast 2.69Hz – 39.70Hz 64 – 127 1
4 Horn Speed Fast 2.69Hz – 39.70Hz 64 – 127 1
5 Slow-Fast Time of Rotor 0 – 127 0 – 127
6 Slow-Fast Time of Horn 0 – 127 0 – 127
7 Drive Rotor 0 – 127 0 – 127
8 Drive Horn 0 – 127 0 – 127
9 Rotor/Horn Balance R63>H – R=H – R<H63 1 – 127
10 —
11–14: Same as the parameters shaded in gray in Cross Delay on page 17.
15 Mic L-R Angle 0deg – 180deg 0 – 60
16 Speed Control Slow, Fast 0 – 1

*3
No. Parameter Range Value Table No. Ctrl
1 Overdrive 0 – 100% 0 – 100

2 Device Transistor, Vintage Tube,
Distortion1, Distortion2,
Fuzz 0 – 4
3 Speaker Type Flat, Stack, Combo, Twin,
Radio, Megaphone 0 – 5
4 Presence -10 – +10 0 – 20
5 Output Level 0 – 100% 0 – 100
6 —
7 —
8 —
9 —
10 Dry/Wet Balance D63>W – D=W – D<W63 1 – 127
11 —
12 —
13 —
14 —
15 —
16 —
No. Parameter Range Value Table No. Ctrl
1 Overdrive 0 – 127 0 – 127

2 AMP Type Off, Stack, Combo, Tube,
Crunch, Hi Gain, British 0 – 6
3 LPF Cutoff Frequency 1.0kHz – 20.0kHz 34 – 60 3
4 Output Level 0 – 127 0 – 127
5 —
6 —
7 —
8 —
9 —
10 Dry/Wet Balance D63>W – D=W – D<W63 1 – 127
11 —
12 —
13 —
14 —
15 —
16 —
No. Parameter Range Value Table No. Ctrl
1 Overdrive 0 – 127 0 – 127

2 EQ Low Frequency 32Hz – 2.0kHz 4 – 40 3
3 EQ Low Gain -12dB – +12dB 52 – 76
4 LPF Cutoff Frequency 1.0kHz – 20.0kHz 34 – 60 3
5 Output Level 0 – 127 0 – 127
6 —
7 EQ Mid Frequency 100Hz – 10.0kHz 14 – 54 3
8 EQ Mid Gain -12dB – +12dB 52 – 76
9 EQ Mid Width 0.1 – 12.0 1 – 120
10 Dry/Wet Balance D63>W – D=W – D<W63 1 – 127
11 Edge 0 – 127 0 – 127
12 Attack 1ms – 40ms 0 – 19 8
13 Release 10ms – 680ms 0 – 15 9
14 Threshold -48dB – -6dB 79 – 121
15 Ratio 1.0 – 20.0 0 – 7 10
16 —