11
CLP-110
12.
Side Cover Assembly (L, R)
(Time required: about 10 min)
*
For safety, this process should be done by two
personnel.
*
To remove screws from the bottom, prepare a
worktable or bolsters to set the main unit.
12-1
Remove the top board assembly. (See procedure 1)
12-2
Remove the key cover assembly. (See procedure 3)
12-3
Remove the end block assembly (L, R). (See
procedure 4)
12-4
Remove the keyboard assembly. (See procedure 8)
12-5
Remove the main unit and set it on the worktable
or the bolsters. (See procedure 11)
12-6
Remove the two (2) screws marked [T9b] for each
side, three (3) screws marked [T9c] for each side
and two (2) screws marked [T5] for each side.
The side cover assembly (L, R) can then be re-
moved. (Fig.9)
13.
Side Board Assembly (L, R) and ST Board
Assembly (Time required: about 3 min)
*
For safety, this process should be done by two
personnel.
13-1
Remove the main unit. (See procedure 11)
13-2
Remove the two (2) screws marked [S1] for each
side. The side board assembly (L, R) and the ST
board assembly can then be removed. (Fig.11)
14.
Stand Base Assembly (L, R) and Foot
(Time required: about 4 min)
*
For safety, this process should be done by two
personnel.
*
The foot can be removed without removing the
stand base.
*
The side board and the two projections (dowels) on
the stand base assembly are joined with bond, so
remove the stand base assembly with a little more
force than usual.
Before reinstalling the stand base assembly, remove
the dried bond on the projections (dowels) com-
pletely and apply new bond to them.
14-1
Spread soft cloth on the floor and lay down the
product carefully on its back. (Fig.12)
14-2
Put bolsters under the both side boards to float the
stand bases from the floor. (Fig.13)
14-3
Remove the three (3) screws marked [4] for each
side. The stand base assembly (L, R) can then be
removed. (Fig.13)
14-4
Remove the four (4) screws marked [2c]. The foot
can then be removed. (Fig.13)
[S1] x 4
Cloth
[3], [4]
Cloth
Stand Base Assembly
Foot
[2c]
(Fig.11)
[S1]:
Bind Head Screw 6.0X16 MFZN2BL (EG360020)
(Fig.12)
(Fig.13)
[2c]:
Flat Head Tapping Screw-1 3.5X20 MFZN2BL (EM030180)
[3]:
Flat Washer 4.0X12X1.0 MFZN2Y (VK287600)
[4]:
Pan Head Tapping Screw 4.0X90 MFZN2Y (V9761000)