Front and Rear of Unit
10
➀
Jumper switch
Plug a plastic shunt into this jumper switch to set up SCSI ID, Parity, Terminator and
Block Size. (
→
P. 20 – 23)
➁
SCSI INTERFACE connector
Insert the connector of the SCSI ribbon cable here. (
→
P. 26, 33)
➂
DC IN connector (The SCSI convertor’s side)
Insert the smaller connector of the power cable (included). (
→
P. 19, 34)
➃
DIGITAL AUDIO OUT connector
If your sound card has a SPDIF (digital audio) input connector, you can connect the
DIGITAL AUDIO OUT connector of the unit to the SPDIF connector using a digital audio
cable (sold separately). (
→
P. 17, 34)
➄
ANALOG AUDIO OUT connector
Connect one end of the 4-pin audio cable to this connector, and the other end to your
computer’s sound card or built-in audio. (
→
P. 16, 34)
➅
DC INPUT connector (The CRW2200 drive’s side)
Insert the bigger connector of the power cable (included). (
→
P. 19, 34)
Rear Panel (with the SCSI Convertor)
➃ ➄
➅
➁
➂
➀