E-35
English
RECORDING A COMPACT DISC
To record programmed tracks
1
Select the CD player so that “CD” appears on the display
by pressing the INPUT selector
or
button, and load
the disc to be recorded., and load a disc on the disc table.
2
Follow steps 2–5 on page 33.
3
Press the PROGRAM button.
*
“PROG” and “P-01” illuminate on the display, and all
track numbers on the disc begin flashing.
4
Use the track number input buttons to select the desired
track number.
5
Repeat step 4 to set more programs for the side A of the
tape. You can select the same track again.
*
Pressing the TIME button displays the total remaining
time on the side of the tape for about 1 second, and
then it is replaced by the display of the next playback
order.
*
If “ERR” appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side A of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
6
After you finish the programming for the side A, press the
TAPE button.
*
“Pu” appears on the display, then you can begin
programming for side B.
7
Repeat step 4 to set more programs for the side B of the
tape. You can select the same track again.
*
If “ERR” appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side B of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
8
Press the EDIT button. (“EDIT” appears on the display.)
The recording is automatically started.
*
The unit searches for a peak level on each track to
adjust the recording level properly. The search is
carried out before recording each track. (While
searching, “LEVEL” flashes on the display, and
recording is paused.)
Notes on tape-editing
•
To check, cancel or correct program data, refer to page
20.
•
The maximum number of tracks that can be programmed
is 20.
•
This function can be used to program up to track number
20. If the disc has more than 20 tracks, track number 20
and thereafter will not be programmed.
-
+
1
2
3
4
5
1
2
3
4
5
6
7
8
6
7
8
9
0
A
B
C
D
E
TIME
PROG
TAPE
EDIT
+
I0
STOP
PLAY/PAUSE
RANDOM
REPEAT
CD
TUNER
TAPE
PRESET
DOWN
UP
PLAY
STOP
REC/PAUSE
SLEEP
POWER
DISPLAY
VOLUME
DECK
PHONO/AUX
TUNER DIRECT
A/B
A/B/C/D/E
PLAY
EFFECT LEVEL
DSP
MODE
SP/PHONES
-
+
Receiver
1
CD Player
1
4
1
3
6
8
A
TRACK
P R O G
2
3
4
5
6
7
8
9
10 11 12
H A L L
1
D S P
O N
Display information during programming
Side of the tape
Next playback order
A
TRACK
REMAIN
P R O G
2
3
4
5
6
7
8
9
10 11 12
H A L L
1
D S P
O N
Selected track number
Total remaining time on
the side of the tape
Programmed track numbers illuminate and
unprogrammed ones flash.
