PREPARATIONS
➤
Placing speakers
En
16
2.1-channel system
Even when no surround speakers are connected, the unit creates the virtual surround
speakers using the front speakers to allow you to enjoy multi-channel surround sound
(Virtual CINEMA DSP).
• Add the center speaker to configure a 3.1-channel system.
■
Setting the speaker impedance
Under its default settings, the unit is configured for 8-ohm speakers. When using a
6-ohm speaker for any channel, set the speaker impedance to “6
MIN”. In this case,
you can also use 4-ohm speakers as the front speakers.
1
Before connecting speakers, connect the power cable to an AC wall
outlet.
2
While holding down STRAIGHT on the front panel, press
MAIN ZONE
z
.
3
Check that “SP IMP.” is displayed on the front display.
4
Press STRAIGHT to select “6
MIN”.
5
Press MAIN ZONE
z
to set the unit to standby mode and remove the
power cable from the AC wall outlet.
You are now ready to connect the speakers.
1
2
9
MAIN ZONE
z
STRAIGHT
SPIMP.8MIN
1 2 3 4 5 6 7 8 9 10 11