Yamaha A-S2000 - Amplifier, Руководство пользователя

Страница: 17 / 212

17
En
■
Bi-wire connection
The bi-wire connection separates the woofer from the
combined midrange and tweeter section. A bi-wire
compatible speaker has four binding post terminals. These
two sets of terminals allow the speaker to be split into two
independent sections. This split connects the mid and high
frequency drivers to one set of terminals and the low
frequency driver to the other pair.
To use the bi-wire connections, the impedance of each speaker
must be 8
Ω
or higher.
• Remove the shorting bars or bridges to separate the LPF (low
pass filter) and HPF (high pass filter) crossovers.
•
To use the bi-wire connections, switch the SPEAKERS selector
to the A+B BI-WIRING position.
■
Connecting to the CD BAL jacks
Connect your CD player with the XLR balanced output
jacks. The pin assignments for these jacks are shown
below. Refer to the owner’s manual supplied with your
CD player and verify that its XLR balanced output jacks
are compatible with the pin assignments.
When connecting, be sure to match the pins and insert the
connector of the “male” XLR balanced cable until you
hear a “click”. When disconnecting, pull out the “male”
XLR balanced cable while holding down the lever of the
CD BAL jacks.
To use the XLR balanced connection, you must switch the
INPUT selector on the front panel to the CD BAL position.
Caution
Notes
Note
1: ground 2: hot
3: cold
“Female” XLR connector
“Male” XLR connector
Eng
lish