Operation
39
2.
Slightly tilt the engine up until the tilt sup-
port bar is automatically released.
3.
Slowly tilt the engine down.
EMU28061
Shallow water
EMU28073
Cruising in shallow water (manual tilt
models)
WARNING
EWM01781
●
Run the boat at the lowest possible
speed when using the shallow water
cruising system. The tilt lock mecha-
nism does not work while the shallow
water cruising system is being used. Hit-
ting an underwater obstacle could
cause the outboard motor to lift out of
the water, resulting in loss of control.
●
Use extra care when operating in re-
verse. Too much reverse thrust can
cause the outboard motor to lift out of
the water, increasing the chance of acci-
dent and personal injury.
NOTICE
ECM00260
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU32741
Procedure
1.
Place the gear shift lever in neutral.
2.
Place the tilt lock lever in the release/up
position.
3.
Slightly tilt the outboard motor up. The tilt
support bar will lock automatically, sup-
porting the outboard motor in a partially
raised position. This outboard motor has
2 positions for shallow water cruising.
ZMU02868
U63V1EE0.book Page 39 Tuesday, March 3, 2009 10:50 AM
©
2019 Yamaha Motor Corporation, U.S.A.
