6-17
INITIAL GAUGE SETUP
If two or more engines with digital network gauges are installed, the initial setup is required for
proper gauge operation.
The ignition switches have to be turned to ON in order from Port to Starboard in 2 seconds or more
interval, which can memorize the engine number into each ECM by a rule.
The 1st turned on ignition switch is memorized as No.1 engine.
The 2nd turned on is memorized as No.2 engine.
This can obtain easier engine number recognition for gauge setup.
When the initial recognition setup has been stumbled, reset the engine number and perform it again
with the tachometer.
For further information, see the installation manual in the rigging kit.
For F350, F300 and F250 [Digital Electronic Control], the digital electronic remote control system
recognizes the engine number automatically, therefore the key switch ON in number order is not
required.
Содержание 2CMH
