Yamaha 2004 XJR1300, Информация о сервисе

Страница: 19 / 28

–14–
V Pass the left rear turn signal light
lead and right rear turn signal
light lead through the hole of the
rear fender respectively.
W Pass the wire harness between
the frame installation section
and storage space rib of the rear
fender.
X Connect the starter motor cable
to face outward at an angle of
about 45 degrees.
T Position of the wire harness, tail
brake light lead, left rear turn sig-
nal light lead, right rear turn sig-
nal lead should be not higher
than the rib height of the rear
fender.
U Clamp the wire harness, left rear
turn signal light lead and right
rear turn signal light lead.
Point the tip of the clamp to the
front side.
P From left: #1, #2, #3, and #4
spark plug leads.
Q Point inward.
R Point outward.
S Secure the wire harness and the
starter cable, on the harness
positioning tape, by use of this
clamp. The front end of the
clamp must be directed down-
ward.
The harness must not deflect be-
tween the T-stud and the clamp.
SPEC
CABLE ROUTING