Yamabiko shindaiwa SBA-LE24, Руководство оператора

Страница: 13 / 84

11
Before you start
Mount the cutting attachment shield on the gearcase
1. Remove the shaft bolt, bolt guard, holder A and holder B
from the gearcase.
2. Align the cutting attachment shield assembly with the gear-
case as shown, and then fit the shield onto the matching
flange on the gearcase.
3. Install the bolts with washers. Firmly tighten all three bolts.
4. Install a washer and nut on each of the three bolts assem-
bled in Step 3, then firmly tighten each nut.
Mount the Blade
1. Install the holder A onto the output shaft.
2. Mount the blade and holder B onto the output shaft, and then
install the bolt guard and shaft bolt (turn bolt counterclock-
wise to install).
3. Align the hole in holder A with the matched hole in the gear-
case, and then use the L-wrench to temporarily lock the out-
put shaft.
1. Shaft bolt 4. Holder A
2. Bolt guard 5. Gearcase
3. Holder B
1. Cutting attachment
shield assembly
2. Gearcase
WARNING

The edger is intended for right-handed operation only.
When correctly assembled, the cutting attachment
shield and shaft must be oriented as shown.
1. Bolts 3. Nuts
2. Washers
IMPORTANT
The three bolts must be firmly tightened against the cutting at-
tachment shield before installing and tightening the nuts.
1. Holder A 2. Output shaft
1. Shaft bolt 3. Holder B
2. Bolt guard 4. Blade