Yale Smart Living HSA6210-R, Установка, программирование, эксплуатация, Страница: 8 / 16

8
-Mounting using screws and wall plugs
1 Loosen the bottom screw
and open the Door/
Window Contact.
2 Knock out the holes on the
base as shown.
3 Drill holes into the
mounting surface using
the holes in the knockouts
on the base as template.
4 Fit wall plugs (if required) and secure with the
screws provided.
5 Fit sensor back together and tighten screw.
6 Test sensor by pressing the test button and
opening and closing the door/window. The LED
should light when the door/window is opened.
Installation is complete.
Mounting the Panic Button
1 Break through the knockouts (where the plastic is
thinner).
2 Using the holes as a template, drill holes in the
surface and insert wall plugs if fixing into plaster or
brick. Screw the rear case to the wall.
3 Replace the cover and tighten the screw.
Mounting the Smoke Detector
1 The base has two mounting slots. Using the slots
as a template, drill holes and insert the wall plugs if
fixing to plaster. Screw the rear case to the ceiling
using the screws provided.
2 Replace the cover.
Knockouts
The tamper switch will automatically reactivate
after one hour. Alternatively you can enable the
tamper switch manually (optional).
See Page 10, Table 1 and Table 2 for manual
tamper switch reactivation using Key Pad or
Key Fob.
i