Yale RH00130S, Инструкция по использованию, уходу и установке

Страница: 15 / 23

13
1. Measure from range top to hood bottom and mark line A.
_ZŒ`
2. Plum and mark center line.
[ (=_ƒ<‘‹“`
\ (!‹;_“<ƒ‹Œ`
ƒ /_Z`Œ^<‹Z =
do not tighten all the way. Note: Wood blocking may
need to be added behind the drywall if no studs are
present. Wall anchors may also be used but check
local codes before using wall anchors.
Œ +"_Z` Š ^
+"Š ^_/Q$=’`
‘ +"
_/Q$’`
third 6 x 1-1/2” screw with washer through inside of hood
^_/Q$’Z`
8. Center and attach duct cover mounting bracket to wall
Š _Z`Œ^
_/Q$’[`
9. Install duct work and seal with aluminum duct tape*.
Re-install junction box with cable lock and install the
_/Q$=’Z`
10. Power up hood to verify all functions and check for leaks
around duct tape.
11. Place telescopic duct covers onto hood and extend
_` " "
_Z`([ƒ^“
Z+
* If using hood in recirculating mode you must secure the
air diverter plate onto wall before installing duct work and
duct covers. Turn to page 14 for more details.
15
7/8
”
Brackets are
pre-installed
8 15/16 ”
26” Min.
1
2
A
B
3
Duct Cover Bracket
CAUTION: At least two installers are
required due to the weight and size of the
hood.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
Cable Lock
_`
be required by local codes. Check with local
requirements and codes, purchase and install
appropriate connector if necessary.
Installation –
Mounting the Hood, RH003
Cable Lock
2
1
FIG. B
FIG. A