Page 2
Pinion Flat
Pinion Flat
RH Door
LH Door
7.
ith spring adjustment nut
toward lock edge of door and closer valves
Facing
for
door
Facing
for
door.
8.
and install 9/64" hex drive socket
head screw from screw pack.
9.
using Arm Indexing
instructions above.
10.
11.
in track assembly. Secure by
pushing in on the retainer clip that extends from the slide block
in the track, until it is flush with the slide block.
w
1.
Locate and drill 1-1/8" (29mm) diameter hole in frame face
for the conduit.
2.
using above
template:
holes for
holes for
.
holes for
3.
using "Preparation for
Fasteners" chart above.
4.
with smoke detector
toward lock edge of frame and open side facing down.
5.
from hook-up box assy.
Units with a 120V to 24V transformer require that
hook-up board be removed from chassis to enable
mounting.
6.
with
conduit hole openings away from hinge edge of frame.
Place Hook-Up Box straps between frame and
chassis. Special conduit nut supplied to anchor 3/4"
conduit fitting.
Opening
Metal Frame
Metal
Door or Frame
Wood or
Composite
Door
Fasteners
8-32 Machine Screw
1/4-20 Machine Screw
3/8 Dia. Sex Nut
Fastener Preparation
Drill: #29 [.136" (3.45mm) dia.]
8-32 UNC Tap
Drill: #7 [.201" (5.10mm) dia.]
1/4"-20 UNC Tap
3/8" [.375" (9.50mm) dia.]
through
1-7/16
(36.5)
4 Holes for Closer:
1/4-20 Machine Screw
or 3/8 Dia. Sex-Nuts
2 Holes for Hook-Up Box
8-32 Machine Screw
For Concealed
Wiring Only
1-1/8 (29mm) Hole
For Conduit
1-1/4
(32)
8
(203.2)
3-5/8
(92)
19
(482.6)
34-11/16 Ref.
(881.1)
11-1/4
(285.7)
12-1/16
(306.4)
2 Holes for Track:
1/4-20 Machine Screw
Hinge or Pivot
• From centerline of pivot point to end
of track and hook-up box is 35-25/32
(909mm)
• Right hand door shown
• Do not scale drawing
• Dimensions are given in inches (mm)
• Closer mounted with sex nuts
requires that door silencers be used
• Minimum ceiling clearance for unit is
2" (50mm)
• Maximum door opening is 110°
5-1/8
(130)
3/4
(19)
6-3/4
(171.4)
2-3/8
(60.3)
Attaching Arm Stud to Slide
Retainer Clip
2
1
80-9344-0705-010 (7-01)
