Check Points after Installation
①
②
Insert Batteries
Insert Remote Control(Optional) module
Take care inserting the Remote Control(Optional) module.
The pins can easily bend and may not be replaced under warranty
③
Inside Lever Voice Handing
When an inside lever is fitted to LH side of door, voice handing will be correct.
No further action required.
When an inside lever is fitted to RH side of door the voice instruction will be opposite.
Eg "lock closed securely locked" when opening the door
.
Follow the simple procedure below to set the correct voice handing.
④
Check The Mechanical Back Up Key Works Properly
- Turn key to 90 degree.
- Press outside lever down & open door.
- Remove key
- Check the operation of the inside handle child safety / security button handle.
The inside lever must not move unless the button is depressed.
When the inside lever returns to horizontal, the button must re-engage to prevent use.
⑤
Check the free movement of both inside & outside levers
※
If the button does not re-engage, please slightly lift up the inside lever to re-engage.
Quick Guide
5
6
Registering Your PIN Code
Registering Your Remote Controls
(Optional)
Family code is the code that you and your family remembers as your PIN.
The visitor code can be given to guests or work people. Once guests or work people have
left you can change the visitor code without you or your family learning a new one.
➞
Press (Registration)
button
➞
➞
Press button to
register
Enter Family code
(4 to 12 digits)
➞
Enter Visitor code
(4 to 12 digits)
➞
※
If you want to use just one PIN Code for family, then skip the
④
~
⑤
th steps and press Registration button.
①
④
②
⑤
③
⑥
Press (Registration)
button to complete
Press button to
register
Please press the 2 marked buttons shown at
the same time for 3 seconds to register,
The remote LED will show red
➞
Press (Registration)
button
①
Register all remote controls
you wish to register
one by one
②
➞
③
Only press (Registration)
button to complete after all
remotes have been registered
