Specification
Conforms to:
EN 300 220-1 / V2.1.1 (2006-04)
EN 301 489 -1, / V1.6.1 (2004-12)
EN 301 489-3, / V 1.4.1 (2002-08)
Environmental conditions:
-10°C to 40°C, relative humidity 70% non-
condensing
Radio:
Microcontroller controlled
433.92MHz AM transmitter.
Battery:
1X 3V CR2032 Lithium Coin Cell,
2 Years life at 50 activations per day.
Programming & testing
Program your door/window contact
before installation and test afterwards.
Please see your current system instruction
book.
Location
Locate the door/window contact
accessory taking into account the
following points:
• Mount as high as possible
• Do not aim a PIR at this door or window
Installation
Screw mounting
1 Break through the knockouts (where the
plastic is thinner).
2 Using the holes as a template, drill holes
in the surface and insert wall plugs if fixing
into plaster or brick. Screw the rear case
to the wall using the knockouts.
Self adhesive installation
Clean the surface with a suitable
degreaser.
1 Remove the protective covering from
one side of the double sided adhesive pad
and firmly apply to the back of the device.
2 Remove the other cover and firmly press
the item onto the desired location.
Do not use the adhesive pad method of
installation on a surface with peeling or
cracked paint, or on a rough surface.
3 Mount the detector base on the frame
and align the magnet.
• The magnet should not be more than
8mm from the detector when the door is
closed.
• Ensure the tamper switch spring is
positioned so that it makes contact with
the mounting surface through the tamper
switch aperture.
• When fitting to a window, fix the magnet
to the moving part and the detector to the
frame.
4 Fix the detector on its base and secure
with screw.
Yale UK
School Street, Willenhall
West Midlands WV13 3PW
Tel +44 (0)1902 364647
Fax +44 (0)1902 364692
E-mail [email protected]
www.yale.co.uk
E1 12/06
DWC Manual 8/12/06 11:51 am Page 2
